Debian does not impose hardware requirements beyond the requirements of the Linux or kFreeBSD kernel and the GNU tool-sets. Therefore, any architecture or platform to which the Linux or kFreeBSD kernel, libc, gcc, etc. have been ported, and for which a Debian port exists, can run Debian. Please refer to the Ports pages at http://www.debian.org/ports/mips/ for more details on Mipsel architecture systems which have been tested with Debian GNU/Linux.
Rather than attempting to describe all the different hardware configurations which are supported for Mipsel, this section contains general information and pointers to where additional information can be found.
Debian GNU/Linux 8 supports ten major architectures and several variations of each architecture known as “flavors”.
|AMD64 & Intel 64||amd64|
|ARM with hardware FPU||armhf||multiplatform||armmp|
|multiplatform for LPAE-capable systems||armmp-lpae|
|MIPS (big endian)||mips||SGI IP22 (Indy/Indigo 2)||r4k-ip22|
|SGI IP32 (O2)||r5k-ip32|
|MIPS Malta (32 bit)||4kc-malta|
|MIPS Malta (64 bit)||5kc-malta|
|MIPS (little endian)||mipsel||MIPS Malta (32 bit)||4kc-malta|
|MIPS Malta (64 bit)||5kc-malta|
|Power Systems||ppc64el||IBM POWER8 or newer machines|
|64bit IBM S/390||s390x||IPL from VM-reader and DASD||generic|
Debian GNU/kFreeBSD 8 supports two architectures.
|AMD64 & Intel 64||kfreebsd-amd64|
This document covers installation for the Mipsel architecture using the Linux kernel. If you are looking for information on any of the other Debian-supported architectures take a look at the Debian-Ports pages.
Debian on Mipsel supports the following platforms:
MIPS Malta: this platform is emulated by QEMU and is therefore a nice way to test and run Debian on MIPS if you don't have the hardware.
Complete information regarding supported mips/mipsel machines can be found at the Linux-MIPS homepage. In the following, only the systems supported by the Debian installer will be covered. If you are looking for support for other subarchitectures, please contact the debian-mips mailing list.
Multiprocessor support — also called “symmetric multiprocessing” or SMP — is available for this architecture, and is supported by a precompiled Debian kernel image. Depending on your install media, this SMP-capable kernel may or may not be installed by default. This should not prevent installation, since the standard, non-SMP kernel should boot on SMP systems; the kernel will simply use the first CPU.
In order to take advantage of multiple processors, you should check to see if a kernel package that supports SMP is installed, and if not, choose an appropriate kernel package.
You can also build your own customized kernel to support SMP. You can find a discussion of how to do this in Section 8.6, “Compiling a New Kernel”. At this time (kernel version 3.16) the way you enable SMP is to select “Multi-Processing support” in the “Kernel type” section of the kernel config.
Debian's support for graphical interfaces is determined by the underlying support found in X.Org's X11 system, and the kernel. Basic framebuffer graphics is provided by the kernel, whilst desktop environments use X11. Whether advanced graphics card features such as 3D-hardware acceleration or hardware-accelerated video are available, depends on the actual graphics hardware used in the system and in some cases on the installation of additional “firmware” images (see Section 2.2, “Devices Requiring Firmware”).
Details on supported graphics hardware and pointing devices can be found at http://xorg.freedesktop.org/. Debian 8 ships with X.Org version 7.7.
Almost any network interface card (NIC) supported by the Linux kernel should also be supported by the installation system; drivers should normally be loaded automatically.