|
I aplogize if this was already sent to the
list. I had some confusion when subscribing and I had sent this before I
got my subscription confirmation back.
Anyway, below is the original
message...
Hello,
I have a PWS 500a. Im using AlphaBIOS and
have correctly set up OS Type. When the floppy boots, it loads loadlin.exe
fine, the starts MILO. When I type "show" or "ls" or "boot blah" at the
MILO prompt, it loads the RAMDISK, finds my cdrom, floppy, and qlogicisp
controller, but hangs after the following two lines:
scsi0: QLogic ISP1020 SCSI on PCI bus 1
device 4 irq 27 base 0x9000
scsi : 1 host.
It just sits here endlessly. I've tried
different versions of Miata, but to no avail. I tried a different hard
drive and scsi cable, also did not help.
I am not familiar with MILO so I do not know what
comes after the above message. Any suggestions would be greatly
appreciated.
Thanks...
Sean Rolinson
snowdog@bigfoot.com
|