How to make SCSI only bootup

[zdrysdal@diagnostic.co.nz]

Hiya

i have a SCSI only system and i am not too sure how to load the drivers for
it to enable it to boot up.  I have specified the SCSI disk to be the boot
disk and it has written the boot/lilo onto it which is good, but when i
boot the machine i only get 2FA:

I presume the SCSI disk needs the drivers loaded in order to make it
boot/run.. but the drivers cannot be loaded because they are stored on the
SCSI :)

hmm

Load the system via floppy which has the SCSI controller on it?

what other alternative is there to make the SCSI boot up without the need
of a floppy?

Thanx


Zane