Re: dhcp
On Sat, Feb 27, 1999 at 11:12:56AM -0500, Thomas and Donna Lopolito wrote:
> has anyone successsfully gotten dhcp to run on a box with 2 ethernet cards?
> If so, then what did you use and how did you setup the dhcpd.conf file?
Hmm. I used the HOWTO. The only problem I had was that the ethernet cards
were 3c509's and were configured to use the same resources (irq, io). I had
to get some utilities to set up the cards, then add some params to LILO to
make them act right.
# dhcpd.conf
#
# Configuration file for ISC dhcpd
#
subnet 192.168.1.0 netmask 255.255.255.128 {
range 192.168.1.10 192.168.1.20;
range dynamic-bootp 192.168.1.21 192.168.1.30;
option subnet-mask 255.255.255.128;
option broadcast-address 192.168.1.127;
option routers 192.168.1.1;
option domain-name-servers 192.168.1.1;
option domain-name "you.lick.cx";
}
subnet 25.4.117.0 netmask 255.255.255.0 {
}
-- Lilo command --
append="mem=128M ether=3,0x280,eth0 ether=10,0x300,eth1"
Hope that helps
--
Reply to:
- References:
- dhcp
- From: Thomas and Donna Lopolito <tomanddonna@lopolito.com>