Re: No USB DVB-T adapter seems to work on NUC 5CPYH
On Fri, 24 Jun 2016 12:28:50 +0200
Nicolas George <george@nsup.org> wrote:
> Le septidi 7 messidor, an CCXXIV, Dominique Dumont a écrit :
> > This message indicates that the key no longer replies on the usb bus. It may
> > be due to a bad hardware, a bug in firmware (or wrong firmware or wrong
> > version).
>
> These are the likely causes, but note that the fault does not necessarily
> lies in the device, it can also be a problem with the USB hub. I have
> observed different kinds of devices (card readers, wireless keyboard
> dongles) working when connected to one hub and not on another.
I have tried other USB ports (I'm not using a hub), but still can't
get it working (get the same message).
> > In my experience, only hauppauge HW works fine (admitedly, my experience is
> > based on 5 devices which is not statistically significant)
>
> I can vouch that this device:
>
> ID 0ccd:0078 TerraTec Electronic GmbH Cinergy T XXS
>
> has been working quite well for seven years, even surviving the switch to
> HD. (The IR remote control receiver does not receive anything despite
> appearing as an input device, though; but a wireless numpad does the trick
> as well; and maybe I am missing something to enable it.)
>
> In general, for hardware support, I would trust the authors' wiki:
>
> https://linuxtv.org/wiki/index.php/DVB-T_USB_Devices
Yes, I looked up the DVT-T2 page on linuxtv.org.
Thank you (and Dominique) for your help.
Reply to: